#HIKVISION IVMS 4200 CLIENT PASSWORD#
This password would have been setup by CLEAR IT SECURITY. Password: This is the password used on or setup on the Hikvision system. This name may be admin or a different name if setup by CLEAR IT SECURITY. User Name: This is the username assigned to you by CLEAR IT SECURITY or the system’s default username/password information. Port: 8000 (unless your installer used a custom port) If your system was installed by CLEAR IT SECURITY, this information would have been emailed to you. Example: Home or Office or JWG Warehouse Building 1, etc.Īddress: Enter the IP address or Dynamic DNS name for the device. This nickname is used to identify your system/location in the iVMS-4200 client. Nickname: Enter a Nickname for this location’s device.
The most commonly used modes encountered here are IP/Domain and Cloud P2P.
The screen once open, will default to an Adding Mode of IP/Domain. If you are adding a device that is on the internet, you should click Add + under Device for Management (0) near the top middle area of your screen.If you are adding a device that is on your local network, you should see it listed at the bottom under Online Device (1) - if you do, just click on it then click Add + under Online Device (1).To add a new device, click on the Add located under Device for Management heading or: Once you have downloaded and installed Hikvision’s iVMS-4200 Client, you can open iVMS-4200 and use the Device Management screen found in the Device Management tab (shown below) and to add, configure new and existing devices, as well as remove devices.
0 kommentar(er)
